Free The Tone Arc-53m 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Free The Tone Arc-53m에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Free The Tone Arc-53m 16 페이지. Audio routing controller

페이지 인쇄

CONTROL PANEL

Display

The numeral shown in the tens place is the bank number and the

numeral shown in the ones place is the number of the preset currently

recalled. When MIDI signals are sent or received, the dot labeled

"MIDI SIG" is lit and when Memory Protect function is active, the dot

labeled "M.PROTECT" is lit.

100 LED

This LED illuminates to indicate number 100 when the MIDI program

change number or MIDI control change number is over 100. For

example, if the 100 LED illuminates and the Display shows "01", then

this means No. 101. When the Display shows the bank or preset

number, this LED indicates the tens of the bank number. If, for

example, the 100 LED illuminates and the Display shows "15", then

this means Bank no. 11, Preset no. 5.

INC/+ and DEC/– switches

Used to change the bank number when in usual mode (Preset mode)

and used to change parameters when in Edit mode.

STORE switch

Used when storing your change to the setting in the preset.

ENTER switch

Used in Edit mode to select the item to be edited or to conﬁrm the

changes you made.

LOCK switch

Used to lock the switches on the control panel, preventing

unintentional tampering. Holding this switch for three seconds locks

the switches and the LED illuminates. Pressing the switch for three

seconds again unlocks the control panel and the LOCK LED goes

off. Note that the INC/+ and DEC/– switches are not locked in order

to change the bank number.

DISP MODE (Display Mode) switch

Used to change operating modes of the LED displays or Select

Switches.

Effect Loop/Control Terminal LED

Indicates the on/off status of each loop (L1–L5) and each control

terminal (C1–C3). Loops can be turned on/off by pressing the

corresponding Select Switches ( ) 1–8.

Select Switches

Used to edit or conﬁrm the contents saved in presets. Note that the

items to be selected vary according to the mode selected by the

DISP MODE switch.

MIDI CH (PC NUMBER) LED

When the Display is set to MIDI PC & CC# mode, pressing any of

the Select Switches ( ) 1–4 selects the corresponding MIDI send

channel. Select Switches 1–4 correspond to MIDI channels CH1–

CH4 respectively. The LED above the pressed switch illuminates and

the MIDI program change number being sent via the current preset is

shown in the Display ( ).

CSW (CC NUMBER) LED

When the Display is set to MIDI PC & CC# mode, this LED indicates

the on/off status of CSW (control switch) function. CSW (control

switch) can be turned on/off by pressing the corresponding Select

Switches ( ).