Free The Tone TA-2H 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Free The Tone TA-2H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Free The Tone TA-2H 8 페이지. Multi-dimensional chorus

페이지 인쇄

Switching presets 1–128 via MIDI

1. Connect an external MIDI controller to the MIDI IN terminal on the TRI AVATAR rear panel.

2. Press the TRI AVATAR's ON/OFF switch to illuminate the LED above the switch.

3. From the external MIDI controller, send the MIDI program change number corresponding to the preset to

be recalled.

NOTE

Be sure to set the same MIDI program change number on the sending device's MIDI channel and the TRI AVATAR

MIDI channel. Setting up MIDI receiving channel

Correspondence between MIDI receiving channels and PRESET LED indications

Confirming the position of each knob stored in the preset

1. Recall the desired preset.

2. Press the EDIT switch. The PRESET LED for the selected preset flashes.

3. Turn the desired knob clockwise or counterclockwise to confirm its stored position in the preset.

The stored knob position is indicated by the PRESET 1–4 LEDs as explained in the note below.

NOTE

The PRESET 1 LED illuminates: The knob is moving in the counterclockwise direction comparing its current

position with the position stored in the preset.

The PRESET 4 LED illuminates: The knob is moving in the clockwise direction comparing its current position with

the position stored in the preset.

The PRESET 2 and PREST 3 LEDs illuminate: The knob is at the same position as stored in the preset.

p.9

➞

p.11

➞

Changing/writing preset contents (Edit mode)

The EDIT LED above the EDIT switch illuminates when the TRI AVATAR is operating in Edit mode. This

mode, activated by pressing the EDIT switch, is for modifying and saving preset contents.

NOTE

By pressing the EDIT switch again after turning the knobs to change parameters in Edit mode, your changes are

canceled and the TRI AVATAR returns to the status in which the original preset is recalled.

When the unit is put in Edit mode from Manual mode

The current Manual mode settings are saved in the preset.

1. Press the EDIT switch to enter Edit mode.

2. Turn the knob for the parameter to be adjusted.

3. To select the preset for saving the settings, press the PRESET switch (preset 1–4) or send the MIDI program

change number corresponding to the desired preset number (preset 1–128) from the external MIDI device.

4. Press and hold the EDIT switch for about 1.5 seconds. The EDIT LED flashes and the saving operation is executed.

When completed, the TRI AVATAR automatically switches from Edit to Preset mode and recalls the preset you've

just saved.

When the unit is put in Edit mode from Preset mode

You can adjust only the desired parameters of the current preset sound and store them in a preset.

1. Press the EDIT switch to enter Edit mode.

2. Turn the knob for the parameter to be adjusted.

3. To select the preset for saving the settings, press the PRESET switch (preset 1–4) or send the MIDI program change

number corresponding to the desired preset number (preset 1–128) from the external MIDI device. If you want to save

your changes to the preset currently being edited, do not select a preset, then proceed to the next step.

4. Press and hold the EDIT switch for about 1.5 seconds. The EDIT LED flashes and the saving operation is

executed. After saving, the contents of that preset number are recalled.