AudioCodes MP-100 빠른 시작 매뉴얼 - 페이지 13

{카테고리_이름} AudioCodes MP-100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes MP-100 17 페이지.

AudioCodes™ MP-100/104 Gateway Quick Start Installation Guide

•

Channel Settings: Configure the Channel Settings field, as described below.

Required for

Caller ID

All settings, except the following, should remain the same as they are shown in the

screen. For more details, refer to the AudioCodes MP-104 User's Manual.

— DTMF Transport Type: Should match the DTMF Encoding Setting on the

IPRC Device page.

If G.711 is selected in the Audio Settings page on the IPRC Web page, the

DTMF Encoding Setting on the IPRC must be G.711, and the DTMF Trans-

port Type and MP Transport Type must be set to Transparent MF.

If G.729 is selected in the Audio Settings page on the IPRC Web page, the

DTMF Encoding Setting on the IPRC must be Out-Of-Band, the DTMF

Transport Type must be set to RFC2833 Relay DTMF, and the MF Transport

Type must be set to Relay MF.

NOTE:

If G711 is selected in the Audio Settings page on the IPRC Web page,

all transport types (DTMF and V21/22/23/32/34 Modem) must be set to Trans-

parent. If G.729 is selected on the IPRC, set the DTMF Transport Type to

RFC2833 Relay DTMF and the Fax Transport Type to Transparent.

— Fax/Modem Bypass Coder Type: Select G711MuLaw for US Systems and

G711Alaw_64 for European Systems.

— If you are using Caller ID receivers, change the following settings as described

below.

•

Caller ID Transfer Type: Select MUTE.

•

Caller ID Type: Select Bellcore.

To apply the changes, click SUBMIT.

March 2004

Page 13 of 17