Casio V.P.A.M fx-100s 매뉴얼 - 페이지 6
{카테고리_이름} Casio V.P.A.M fx-100s에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Casio V.P.A.M fx-100s 16 페이지.
Casio V.P.A.M fx-100s에 대해서도 마찬가지입니다: 매뉴얼 (17 페이지)
페이지 인쇄¢ (4) - CMPLX
Mode
2 Press the number key that corresponds to the unit
Specify this mode to perform complex number
calcu
of angular measurement mode you want to scecify.
ar
Use this mode to specify degrees as the unrt of angu-
a Specifying the BASE-N Mode
lar measurement. The 'DEG" indicator is shown on the
J
Press the
key five times and Mode Specifica display when the unit is in the DEG Made.
Use this mode to specify radians as the unit of angutar
measurement.
The RAD"
indicator is shown
on the
BASEN
display when the unit is in the RAD
Mode
1
+ (3) - GRA Mode
Use this mode to specify grads as the umit of argular
measurement.
The ''GRA"' indicator is shown on the
om
display when the unit is in the GRA Made.
(2) Press the number
Mode
Key to specify the BASE-h «The DEG, RAD, and GRA modes can be used in any
calculation
mode
except
the
BASE-N
Mode.
'
=
Whenever power is switched off by the Auto Power
Ui} - BASE-N
Mode
Off function, restonng power automatiaily enters the
Enter this mode t
rfor
inary
G Pemorm conversion between binary
act mode you were in when power switched off.
the BASE-N Mode.
'1, Press the bea] key three times and Mode Specifica-
M Specifying an Angie Unit Mode
2, Press the number key that corresponds to the dis-
(1) Press the
key two times and Mode Specifica.
Play mode you want to specify.
tion
Menu
No.
2 appears
as
shown
below.
The
foliowing
describes
the
meaning
of each
mode.
« (1) - FIX Mode
Use this mode to specify the number of decimal places
to the right of the decimal point. The ''FIX"' indicator
is shown on the display when the unrt is in the Fix
Mode.
When you enter this mode, the message "0 ~ 9?"' ap
pears on the display. Press a number key from (Qj to
to specify the number of decimal places.
—~9-
-~10-