AudioCodes 420HD 빠른 매뉴얼 - 페이지 2
{카테고리_이름} AudioCodes 420HD에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes 420HD 2 페이지. Ip phone with microsoft lync server
AudioCodes 420HD에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지), 빠른 매뉴얼 (4 페이지), 빠른 매뉴얼 (2 페이지)
페이지 인쇄
3. Cabling the Phone
Warning: Prior to connecting power, refer to the Compliancy and Regulatory
Information at www.audiocodes.com/library.
To cable the phone:
1.
Connect the short, straight end of the phone
cord to the handset and the longer straight end
of the cord to the handset jack on the phone.
2.
Connect the RJ‐9 headset jack to a headset
(optional).
3.
Connect the RJ‐45 LAN port to your LAN
network (LAN port or LAN switch/router) with
a CAT 5 / 5e Ethernet cable.
4.
Connect the RJ‐45 PC port to a computer
with a CAT 5 / 5e straight‐through Ethernet cable.
5.
Connect the connector tip of the AC power adapter to the
phone's DC 12V power socket and connect the two‐prong
AC adapter directly to the electrical wall outlet.
When the phone powers up, all the LEDs momentarily light up.
4. Attaching Phone Base Stand to Phone Unit
Desktop mounting: Slide outer rails (A) of phone stand onto outer notches (A).
Wall mounting: Slide middle rails (B) of phone stand onto inner notches (B).
Desktop Mount
Wall Mount
Push this button to
detach stand
5. Upgrade IP Phone Firmware
If you need to upgrade your phone's firmware, refer to the Software Upgrade Configuration Note,
downloadable from http://www.audiocodes.com/downloads.
6. Basic Phone Operation
To make a call:
Pick up the handset, enter a phone number and then press the Dial softkey.
To call a phone contact, press the directory icon softkey, access the Corporate or Personal
directory, select the contact and then press the Dial softkey.
To answer a call:
Pick up the handset, or press the speaker
To end a call:
Return the handset to the phone cradle, or press the End softkey, or press the
speaker
or headset
key.
To mute a call:
Press the mute
again.
To redial a number:
Press the REDIAL key, select a dialed number, and then press the Dial
softkey.
To put a call on hold and make another call:
number and press the Dial softkey. To return to the held call, press the down key and then
press the Resume softkey.
To transfer a call:
8. Basic Phone Operation
During a call, press the TRANSFER key, enter the phone number to where you want to
1.
transfer the call, and then press the Dial softkey.
Either wait until the call is established to speak with the second party and then press the
2.
Trans softkey, or press the Trans softkey when the called party rings to transfer the call
without speaking with the party.
or headset
key. To resume the conversation, press the mute key
Press the New Call softkey, enter a phone
key.