DUOTECNO DT0C-10X 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} DUOTECNO DT0C-10X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DUOTECNO DT0C-10X 9 페이지. Tft touchscreen 10.1"

Installation

Mount the recessed box in the wall. Make sure it's level mounted!

Mount the bracket in the recessed box. This with the use of four supplied bolts (m3x10). (see figure 1).

Connect all the needed cables (bus, power, ethernet) on the Touchscreen 10".

Mount the Touchscreen 10" in the mounted bracket (see figure 2-4).

Mount the finished front, This one holds up with the built-in magnets on the bracket. You will find the wide split at the underside (see figure 5).

Note: it's recommended to restart the power supply of the Touchscreen with the use of the automate, after placing the finished front. This way

the Touchscreen will recalibrate its Touch-detection, depending on the chosen finish.

Figure 2Bracket in flush-mounted box

Figure 2 Bring Touchscreen to bracket

EXTENSIONS

DT0D-10

DT0D-10S

DT0D-WI

The warranty is void if:

the device is not correctly installed and/or connected;

the damage or the defect is a result of repairs and/or changes in the device that are made by an agency or dealer not authorised by us;

the defect is caused because non-original and/or non-compatible accessories were connected;

the defect is caused by fire, lightning, flooding or another natural calamity or accident;

the defect is caused as a result of transport.

The warranty is limited to the replacement of parts we have found to be defective.

The warranty does not include shipment and transport cost nor travel and labour costs.

Figure 3 Touchscreen against

bracket

Videophone SIP

Microphone and speakers for connection to a SIP based videophone-installation

Videophone SIEDLE

Microphone and speakers for connection to a SIEDLE based videophone-installation

Wifi adapter

For connection with wifi networks where cabled ethernet is no option

Figure 4 Lower the touchscreen

Figure 5 Mount the finish on the

bracket