AudioCodes M500Li 구성 매뉴얼 - 페이지 9

{카테고리_이름} AudioCodes M500Li에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes M500Li 15 페이지. Voice gateway basic configuration

1. Getting Started with Initial Connectivity

1.3.2

Configuring the WAN Interface

This procedure describes how to configure the WAN interface and uses Gigabit Ethernet.

Before configuring the WAN interface, make sure that you have all the required

information from your Internet Telephony Service Provider (ITSP)

To configure a WAN IP address:

Connect the WAN port to the WAN network.

For information on cabling the WAN port, refer to the Hardware Installation Manual.

Open the WAN Interface page (Setup menu > IP NETWORK tab > CORE ENTITIES folder >

WAN Interface).

In this page you can set:

•

WAN SETTINGS (Static or DHCP Client - Default WAN interface is DHCP Client)

•

DNS SETTINGS (Static or Auto - Default DNS settings is Auto)

1.3.3

To enable remote Web-based management (HTTP/S) from the WAN:

Open the WEB Settings page (Setup menu > Administration tab > Web & CLI folder > WEB

Settings).

Allow WAN access:

•

For HTTP: From the 'Allow WAN access to HTTP' drop-down list, select Enable.

•

For HTTPS: From the 'Allow WAN access to HTTPS' drop-down list, select Enable.

Apply

Click

and save to flash.

- 7 -

M500Li Analog VoIP Gateway