AudioCodes Mediant 800Ci uCPE 빠른 설정 매뉴얼 - 페이지 4
{카테고리_이름} AudioCodes Mediant 800Ci uCPE에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes Mediant 800Ci uCPE 12 페이지.
페이지 인쇄
5
//
Reset pinhole button for resetting the device or restoring it to factory defaults. To
restore to factory defaults: with a paper clip or any other similar pointed object, press
and hold down the button for at least 12 seconds (but no more than 25 seconds).
6
S0 / WAN
WAN Ethernet ports:
DSL: RJ-11 port for DSL WAN interface.
and then Idle Sequences
GE: RJ-45 port for Gigabit Ethernet WAN interface.
SFP: SFP transceiver module for fiber optic WAN.
7
S1 / GE LAN
LED indicating Gigabit Ethernet LAN
8
S2 / BRI
RJ-45 ports for connecting BRI ISDN terminal equipment such as ISDN telephones or
PBXs.
Green On
Green Fast-Flashing
Green Slow Flashing
Green Two Fast-Flashes
Off
Green On
Green Flashing
Off
Green On
Green Flashing
Off
Green On
Green Flashing
Off
Green On
Red On
Off
4 |
DSL link connected (trained) with peer ("showtime").
Training up (connection in progress) and negotiating with
peer.
DSL port administratively up, but idle (not connected and
no peer detected).
DSL port initializing itself after being enabled or upon
mode change.
DSL port administratively shutdown or not configured
WAN GE link established.
Data received or transmitted.
No WAN GE link or power not received by the device.
WAN fiber link established.
Data received or transmitted.
No WAN fiber link.
Ethernet link established.
Data received or transmitted.
No Ethernet link.
Physical layer (Layer 1) is synchronized (normal
operation).
Physical layer (Layer 1) is not synchronized.
Trunk is not active.
P a g e