AudioCodes Mediant 2600 빠른 설정 매뉴얼 - 페이지 3

{카테고리_이름} AudioCodes Mediant 2600에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes Mediant 2600 8 페이지. Session border controller

Physical Description of Rear Panel

AC power supply inlet (100-240V~2.5A, 50-60 Hz) for Power Supply module #1.

AC power supply inlet (100-240V~2.5A, 50-60 Hz) for Power Supply module #2.

Electrostatic Discharge (ESD) lug.

Protective earthing (grounding) screw.

Mounting the Device

You can mount the device on a desktop using the four anti-slide bumpers (supplied), which you need to stick on

the grooves located on the underside of the device.

You can also mount the device in a standard 19-inch rack, by placing it on a pre-installed rack shelf (not

supplied), and then securing the device to the rack frame using front-mounting brackets (supplied).

For additional 19-inch rack mounting options, refer to the Mediant 2600 E-SBC Hardware Installation Manual.

The device is powered from a standard alternating current (AC) electrical wall outlet. The device provides two

hot swappable, power supply modules for power load sharing and 1+1 AC power redundancy in case of failure

of one of the modules.

If you are using both Power Supply modules, ensure that you connect each one to a different AC power



supply source. The two AC power sources must have the same ground potential.

The device must be connected (by service personnel) to a socket-outlet with a protective earthing



connection.

3 |

P a g e