AudioCodes Mediant 3100 빠른 설정 매뉴얼 - 페이지 9
{카테고리_이름} AudioCodes Mediant 3100에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes Mediant 3100 10 페이지. Sbc and gateway
페이지 인쇄
Safety Precautions
The device must be installed and serviced only by qualified service personnel.
The device is considered as IPX0 non-water ingress protected and therefore, must be installed only
indoors.
Do not expose the device to water or moisture.
Ethernet cabling must be shielded and routed only indoors, and must not exit the building.
Do not open or disassemble this device. The device carries high voltage and contact with internal
components may expose you to electrical shock and bodily harm.
Make sure the device is installed in a well-ventilated location to avoid over heating of internal
components and subsequent damage.
Do not place any object on top of the device and make sure that sufficient clearance from the front and
rear are maintained to ensure proper airflow to avoid over heating of internal components.
Operate the device in an ambient temperature (Tma) that does not exceed 40°C (104°F).
The device must be installed only in restricted access locations that are compliant with ETS 300 253
guidelines where equipotential bonding has been implemented.
Operate the device only from the type of power source indicated on the chassis.
Installation of the device must be in accordance with national electrical codes and conform to local
regulations.
Use only the supplied AC power cord for connection to the power source.
The device must be connected to an electrical socket-outlet providing a protective earthing connection.
If you are using both Power Supply modules, connect each one to a different AC power supply source.
The two AC power sources must have the same ground potential.
9 |
P a g e