3Ware 3WARE 9650SE 사용자 설명서 - 페이지 11

{카테고리_이름} 3Ware 3WARE 9650SE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Ware 3WARE 9650SE 11 페이지. Remote battery board
3Ware 3WARE 9650SE에 대해서도 마찬가지입니다: 사용자 설명서 부록 (1 페이지), 사양 (7 페이지), 설치 매뉴얼 (4 페이지)

페이지 인쇄

Updating the Firmware

Uninstalling 3ware Software Under

OpenSolaris

www.3ware.com

Firmware updates to the 3ware RAID controller can be done from CLI or by

using the bootable CD image.

For details on updating the firmware using the CLI, see the discussion of the

command /cx update in the 3ware SAS/SATA RAID Controller CLI

Guide.

For details on using the bootable CD image, see "Updating the Firmware

Through DOS Using the 3ware Bootable CD," in Chapter 10 of the 3ware

SAS/SATA RAID Software User Guide.

Electronic versions of these documents are available at

http://www.3ware.com/support/userdocs.asp.

Note:

After updating the firmware, a complete system shutdown and reboot is

required.

The following steps describe how to uninstall software on OpenSolaris from

the command line. If you do not use the -console option, the installer will

assume you want GUI mode. You must be root to run the uninstaller.

To uninstall software under OpenSolaris

Navigate to the directory where you installed the software. The default

directory is /opt/AMCC.

Change to the subdirectory "_uninst".

To uninstall in text mode, type:

./uninstall.bin -console

To uninstall in graphical mode, type:

and press

./uninstall.bin

Follow the prompts to remove the installed components.

Updating the Firmware

and press

Enter

Enter.