3Ware 9000 Series 릴리스 정보 - 페이지 4

{카테고리_이름} 3Ware 9000 Series에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Ware 9000 Series 9 페이지. Serial ata raid controller release 9.2.0
3Ware 9000 Series에 대해서도 마찬가지입니다: 사양 (2 페이지)

페이지 인쇄

Important Issues

Red Hat WS3.0 driver does not work with older (or newer) versions

The drivers provided in release 9.2 for Red Hat Enterprise WS3 are for Update 3 only.

If a driver is needed for an earlier version (Update 2) or for a newer version (Update 4),

you can build your own driver using the knowledgebase article 11843:

http://www.3ware.com/kb/article.aspx?id=11843

Red Hat – Additional configuration required for AutoCarving (Multi LUN support)

under Linux 2.4 (not required for Linux 2.6)

To allow multi LUN to work an 'options' line needs to be added to the

/etc/modules.conf

e.g.

options scsi_mod max_scsi_luns=8

alias scsi_hostadapter 3w-9xxx

If the system is booting from the 9500S controller (i.e. the array is primary storage)

then the initrd image also needs to be updated:

e.g. /sbin/mkinitrd –v –f /boot/initrd-<kernel>.img <kernel>

e.g. /sbin/mkinitrd -v -f /boot/init-2.4.21-4.EL.img

init-2.4.21-4.EL

Fedora Core 3 - 3DM 2 installer does not work completely with Fedora Core 3

The install script for the 9.2 code set for 3DM 2 was not designed for Fedora Core

3, so you must do some additional steps as described below. This is true for other

non supported distributions as well. See KB article 12692

http://www.3ware.com/kb/article.aspx?id=12692:

1. Install 3DM 2:

./install.3dm

2. Untar 3dm-lnx.tgz

tar zxvf 3dm-lnx.tgz

3. Copy rc.redhat to /etc/rc.d/init.d/3dm2

cp rc.redhat /etc/rc.d/init.d/3dm2

4. Type:

chkconfig --add 3dm2

720-0123-00 Rev. A

Errata

file above the controller entry: