Dupla MultiControl 사용 설명서 - 페이지 3

{카테고리_이름} Dupla MultiControl에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dupla MultiControl 16 페이지.
Dupla MultiControl에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

Introduction

All electronic components of the aquarium computer must only be operated in sound condition. If the feeder

is damaged please have this replaced by a technician or send us the equipment for repair. Continued operation

may cause a fatal electric shock. Ensure that the controller (1) and power unit (12) do not come into contact

with water.

It is good practice to disconnect all electrical equipment from the mains before placing your hands in the

aquarium.

Hint: It is recommended to use a separate or dedicated, safety-switch protected supply which disconnects the

mains from the aquarium equipment in the event of an electrical fault.

Power unit

The Power unit (12) should

be fixed onto the side of

the aquarium cabinet, to

minimise any chance of

water contact in the event

of a leakage from the

aquarium or filter etc.

Temperature Sensor

Position the temperature sensor (11) at a place in the aquarium where

there is a good water current. It should not be attached near heating.

Be sure to mount it securely so that it cannot come loose nor emerge

from the water - this could lead to inaccurate displayed values and over-

heating of the aquarium.

Controller

The controller (1) has a mounting recess or slot (2) on the back, which mates with the

mounting rail (3), and may therefore be mounted using the screw set, (4) to a wall or the

aquarium cabinet. The 2 metre cable from the Power Unit, provides sufficient length to

allow positioning of the controller outside the aquarium furniture, so that all values and

switch states can be readily viewed.