AETOOL BSA-12 사용자 설명서 - 페이지 4

{카테고리_이름} AETOOL BSA-12에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AETOOL BSA-12 7 페이지. Battery & starter analyser

2. Select

for battery test and then press

3. If the tester detected that the battery has surface charge it will prompt you to turn the ignition

key to ON and switch on the headlights to discharge the battery until it has reached to the

next display that shows turn ignition OFF and headlights OFF as display shown below and

then press

to continue.

4. If the battery state of charge (SOC) is below 12V, then it will display as below to remind you

that the battery has low voltage and you wish to continue, just press

5. Next it will prompt you to select the types of batteries: SLI battery meant that it tests normal

flooded types like Wet Low Maintenance (Sb/Ca), Wet Standard (Sb/Sb) Batteries.

6. If AGM (Flat/Spiral) is selected, then it will test Wet (MF) Maintenance Free (Ca/Ca),

AGM/Gel Cell VRLA (Ca/Ca) Batteries.

7. Once the selection has been done, it will proceed to the display as shown below:

8. Before selecting the ratings 'CCA, SAE, EN, IEC, DIN, CA and JIS #' from the menu, check

the battery specification value. This value can be checked on the battery labels as some of

the examples shown below:

to proceed.

State of Charge (SOC)