Audiocom Audiocom PS-2001L 사용자 설명서 - 페이지 15

{카테고리_이름} Audiocom Audiocom PS-2001L에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiocom Audiocom PS-2001L 16 페이지. Telex ps-2001l power supply: user manual
Audiocom Audiocom PS-2001L에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)

페이지 인쇄

Power-Up Check

Plug in any DC wallpacks that are being using with indi-

vidual intercom stations.

NOTE: If you plug in DC wallpacks after applying power to

the PS2001L or SPS-2001, you may get an overload

indication. This is because the stations that are being

their own DC wallpack supplies are connected. To correct

the problem, plug in the DC wallpacks.

Plug in the AC power cords for any connected PS-2001L

or SPS-2001 Power Supplies. The channel status

indicators should be green.

If a channel status indicator turns red during operation,

locate the short or overload that is causing the problem.

Once the short or overload is corrected, the Power Supply

should reset itself and the overload indication should go

away.

Specifications

General

Input Power Requirements

100 to 240 VAC, 50/60 Hz

Output Power (each channel)

21 ±1 VDC, 2 A

Dimensions

1.75" (44.5 mm) high x 8.25" (209.5mm) wide x 10.31" (261.9mm) deep

Weight

approximately 2.5 lb. (1.13 kg.)

Environmental Requirements

Storage:

-20° C to 80° C, 0% to 95% humidity, non-condensing

Operating:

0° C to 50° C, 0% to 95% humidity, non-condensing

Intercom Channels (General)

Connector Type:

One XLR-3M audio connector for each channel. Pin-out depends on setting

of BAL/UNBAL switch for balanced or unbalanced operation as defined

below:

Balanced Mode (set to BAL position)

Line Terminating Impedance: 300 ohms ±10%

Connector Pinout

Pin 1

Common (audio and DC return)

Pin 2

Full-duplex, balanced intercom audio and +24 VDC output

Pin 3

Full-duplex, balanced intercom audio and +24 VDC output

Unbalanced Mode (set to UNBAL position)

Line Terminating Impedance: 150 ohms ±5%

Connector Pin-out:

Pin 1

Common (audio and DC return)

Pin 2

+24 VDC output

Pin 3

Full-duplex, unbalanced intercom audio high

Speaker Inputs (SPS-2001 only)

Type:

RCA Phone Jack

Tip:

Speaker + Input

Sleeve: Speaker - Input

Approvals

UL, CUL, CE