Audiocom Audiocom PS-2001L 사용자 설명서 - 페이지 6

{카테고리_이름} Audiocom Audiocom PS-2001L에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiocom Audiocom PS-2001L 16 페이지. Telex ps-2001l power supply: user manual
Audiocom Audiocom PS-2001L에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)

페이지 인쇄
Introduction
Combine/Isolate Switch: When in the Combine position, the unit will combine the audio signals of the two channels to
1.
create a single audio channel where all users can intercommunicate. When in the Isolate position, the unit will create two
groups of completely independent users.
Channel Status Indicators: The indicators are green for normal operation and red when there is an overload or short circuit.
2.
The circuitry in the unit will automatically reset when the overload or short circuit is located and fixed.
Universal AC Power Input: The unit accepts any input power in the range of 100-240 VAC, 50/60 Hz.
3.
Intercom Channel Connectors: When the Combine/Isolate switch is set to the Isolate position, each channel connector is
4.
powered separately and has completely separate intercom audio. When the Combine/Isolate switch is set to the Combine
position, each channel is still powered separately, but the audio signals are combined so that all users on both channels can
intercommunicate.
BAL/UNBAL Selector Switch: This selector switch allows the user to configure the unit for use in either an Audicom
5.
(BALANCED) or Clear-Com (UNBALANCED) system. Compatibility includes channel connector pin-outs, channel
power requirements, and call signaling requirements. The default setting for this switch is in the Audiocom
position.
®
4
100-240 VAC 60/50 HZ
TELEX COMMUNICATIONS, INC. MADE IN USA
SPS-2001 Front and Rear Panel Features
FIGURE 2.
Speaker, Inputs, and Volume Control: Two audio inputs are provided. The inputs are combined internally and set as a
1.
monaural signal to the internal speaker amplifier. The Volume control adjusts the level to the front panel speaker. Typically,
these inputs are used with the speaker outputs of a master station when the master station is set for use with a panel
microphone and speaker instead of a headset.
Combine/Isolate Switch: When in the Combine position, the unit will combine the audio signals of the two channels to
2.
create a single audio channel where all users can intercommunicate. When in the Isolate position, the unit will create two
groups of completely independent users.
Channel Status Indicators: The indicators are green for normal operation and red when there is an overload or short circuit.
3.
The circuitry in the unit will automatically reset when the overload or short circuit is located and fixed.
Universal AC Power Input: The unit accepts any input power in the range of 100-240 VAC, 50/60 Hz.
4.
4
Volume
1
CH 1
INPUT 1
SPEAKERS
LINE LEVEL
1VRMS
UNBAL
BAL
INPUT 2
6
SPS-2001
1
Combine
2
Isolate
2
3
5
CH 2
CLASS 2 WIRING 1.5A 24VDC
®
®
(BAL)