AudioControl ACM-2.300 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} AudioControl ACM-2.300에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioControl ACM-2.300 13 페이지. Compact high power 2-channel amplifier, high current design, 2x75 watts @ 4 ohms, 2x150 watts @ 2 ohms, 1x300 watts @ 4 ohms, bridged mono, 12 db/octave linkwitz-riley alignment crossover, gto signal sense great turn on, 2 line-level rca inputs, 2 active

페이지 인쇄

Connection Panel Features

1. Fuse 30A – Replace the fuse only with the exact same style and

Ampere rating. Disconnect 12V power before changing or inspect-

ing the fuse.

2. Power Input Terminal +12V – This screw terminal connects to

the +12V battery binding post of the vehicle. Use quality insulated

wiring of the recommended wire gauge, such as wire gauge 8 or

thicker. Thinner wire may cause an overheating hazard due to the

large currents involved.

3. Remote Power Input Terminal – This screw terminal connects

to the 12V remote trigger output of some head units. When the

head unit is turned on, then the ACM-2.300 amplifier will turn on.

Alternatively, you can use the GTO™ feature of the amplifier so it

will turn on when an audio signal is detected at the speaker-level

or line-level inputs.

4. Power Input Terminal Ground – This screw terminal connects to

a good ground connection on the vehicle.

5. Speaker-Level Inputs – The ACM-2.300 amplifier is supplied with

a standard 4-conductor plug that allows for easy installation and

removal. The speaker-level output from amplifiers and factory

installed radios can connect here. Make sure that you follow

the plus and minus polarity markings on the ACM-2.300 and

match it to the polarity of the speaker wiring. Do not use the RCA

Line-level inputs if you are using the speaker-level inputs.