DupliM 140104 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} DupliM 140104에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DupliM 140104 2 페이지. 1:1 ssd/hdd copy cruiser ide/sata
페이지 인쇄Getting Started
Loading the Hard Drives
1. Open the drive tray doors by lifting the tab on the left side of each drive bay you wish to use.
2. Take the Hard Disc Drive (HDD) and align the drive's IDE plug to the lower right hand side of the drive bay.
3. Slide the HDD into the drive bay until it stops. The drive will still be about 1 inch outside of the bay. When the door is closed it
will push and plug the HDD into the duplicator.
4. Swing the drive bay door closed and press the left side of the door until the tab latches. When it latches, a click can be felt and heard. Note: If you are
duplicating, the source hard disk drive goes in the top bay.
Copy HDD
The "Copy" function performs a copy from a source HDD to one or more target HDDs. The target HDDs must be at least as large
as the source. The SSD/HDD Copy Tower IDE/SATA will copy every block of capacity on the source HDD.
1. Load the source HDD and the target HDDs into the SSD/HDD Copy
Tower IDE/SATA. The system will auto-detect
the hard drives. After the drives have been detected, a screen
similar to the one to the right will be displayed.
Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.
2. Press OK to start copying. The system will auto-detect the hard drives. The following information will be displayed.
Copy
Searching Source
Analyzing Source
Partition #1
3. During the copy process the SSD/HDD Copy Tower IDE/SATA will display progress information.
The amount of data remaining to be transferred (shown in gigabytes),
and time will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one
hard drive to another.
4. Once duplication is complete, a job status screen will be displayed.
Please refer to the User Guide found on the flash drive for
more detailed information.
Technical Support Addresses and Phone Numbers
• By e-mail: [email protected]
• By Telephone: +1-818-678-0484
• Technical Support Group can be reached 8:00 AM to 5:00 PM, Pacific Time, Monday through Friday,
excluding U.S. holidays.
Please try to call from a phone near your computer system.
©
2022 DupliM Inc. 21722 Lassen Street / Chatsworth, CA 91311 U.S.A.
Specifications subject to change without notice.
OK
ESC
OK
25%
ESC
2014/10/07
10:50
1. Copy
Copy
Analyzing Source
Copy
50.9G
1 Ready
Copy x1
7:35 26%
Pass: 1
Fail: 0
Time: 20:18
Document Number:
OK
ESC
OK
ESC
OK
ESC
OK
50.9 G
13.5 G
ESC
OK
ESC
140104 ENG QSG Rev A