Acer XD1250D series 매뉴얼 - 페이지 40
{카테고리_이름} Acer XD1250D series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer XD1250D series 45 페이지. Acer projector user's guide
페이지 인쇄
Appendices
Warning: Lamp
compartment is hot!
Allow it to cool down
before changing lamp!
Warning: To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
38
English ...
Replacing the lamp
The projector will detect the lamp life itself. It will show you
a warning message "Lamp is approaching the end of its useful
life in full power operation. Replacement Suggested!" When
you see this message, changing the lamp as soon as possible.
Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
1
2
Lamp Changing Procedure:
1. Turn the power off the projector by pressing the Power button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screw from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
5
3
4