Duplo DB-200 운영 매뉴얼 - 페이지 18

{카테고리_이름} Duplo DB-200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duplo DB-200 18 페이지. Perfect binder

페이지 인쇄
Duplo DB-200 운영 매뉴얼
Name
Default Time
TR1
4 sec.
TR2
1 sec.
TR3
2 sec.
TR4
1 sec.
TR5
.5 sec.
TR6
5 sec.
The fastest speed of settings that AUTO mode can perform is:
TR1 = 2 sec., TR2 = 0.5 sec., TR3 = 1 sec., TR4 = 0.5 sec., TR5 = 0.5 sec.
• Note that the book making speed depends on thickness of the book and the loading
technique for the paper and cover.

ERROR DISPLAY:

LED Display
Description
ERR = L1
Clamp station is
not in the home position.
ERR = L2
Clamp station is
not in the left holding
position.
ERR = L3
Nipping station is unable
to reach the lowest
position.
ERR = L4
Nipping station is unable
to reach the highest
position.
ERR = T1
After warm up more than
one hour, binder is not
ready to bind.
TEMP ERROR
Temperature too low.
HALF00
Skip from Cold to Hot.
Note:
Check all electrical connectors of appropriate items when
troubleshooting errors.
Range
Description
2.0 - 10 sec.
Nipping time.
0.5 - 5 sec.
Auto mode: After loading the cover, the
delay time before clamp station returns.
1.0 - 5 sec.
Auto mode: Clamp closing time
for the book.
0.5 - 5 sec.
Auto mode: Clamp opening
time for the book.
0.5 - 5 sec.
Auto mode: The clamp detecting time
right after closing.
3.0 - 10 sec.
Padding mode: The closing
time of clamp before opening it.
Cause of Error
1. MT1 - fuse blown.
2. LS1 - sensor is bad.
3. MT1 - motor problem.
1. MT1 - fuse blown.
2. LS2 - sensor bad.
3. MT1 - motor problem.
1. MT2 - fuse blown.
2. LS3 - sensor bad.
3. MT2 - motor problem.
1. MT2 - fuse blown.
2. LS4 - sensor bad.
3. MT2 - motor problem.
1. Heater fuse blown.
2. Temperature switch bad.
3. Heater bad.
1. Heater fuse blown.
2. Temperature switch bad.
3. Heater bad.
1. Temp2 sensor bad.
2. Thermostat bad.
15