Audiodesksysteme Gläss Vinyl Cleaner PRO 사용 설명서 - 페이지 11
{카테고리_이름} Audiodesksysteme Gläss Vinyl Cleaner PRO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiodesksysteme Gläss Vinyl Cleaner PRO 14 페이지.
Audiodesksysteme Gläss Vinyl Cleaner PRO에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)
9
Cleaning the device
CAUTION !
Pull out the mains plug from the power socket before cleaning the device.
The device must not be put in water.
Cleaning the outside surfaces
- The outside surfaces can be cleaned with a damp cloth. Use a mild household detergent or
cockpit spray to remove more severe dirt.
Cleaning the water tank
- When the cleaning liquid is changed or the device emptied completely because it is not in
use anymore, slightly tilt the device before draining the cleaning liquid, so that dirt particles
are flushed out. Then drain off the cleaning liquid. Repeat this several times during draining
until the water tank is completely empty.
Cleaning the rinsing chamber
- After use and drying the rinsing chamber can be blown out with air.
10 Changing the cleaning barrels
The four microfiber cleaning barrels last a long time, but they should be replaced after approx.
500 cleaning cycles. This reduces the risk of the records being scratched by residue on the barrels.
If the device is not used for several weeks, the microfiber cleaning barrels should be checked to see
if they have gone hard, and replaced if necessary in order to avoid damage to the record.
Fixture for the cleaning barrels
1.
Pull the cleaning barrels off upwards
2.
Put new barrels on the shaft (2) and
push them down carefully.
3.
Rotate the barrels and press them down
slightly until the drive pins (1) slide into the
2
corresponding holes in the barrels.
4.
Press the barrels down all the way to the
end stop.
1
V 1.0/2016 Page 11 of 14