audiodinamica SUT 3 사용 설명서 - 페이지 6
{카테고리_이름} audiodinamica SUT 3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. audiodinamica SUT 3 12 페이지. Moving coil step up transformer
페이지 인쇄3. INSTALLATION AND OPERATION
Place the SUT n°3 in a suitable location close to your turntable and phonostage input. It is
important to remember that the Step Up Transformers inside the SUT n°3 are susceptible
to noise created by power supplies, mains cables etc. even if SUT n°3 is properly screened.
Once located, connect the SUT N°3 to your turntable and to your phonostage input.
Connect your tonearm/turntable output cables to the input sockets on the SUT N°3 and the
output sockets of the SUT N°3 to your MM phonostage input.
In the figure 3 is represented the back panel of the SUT n°3.
Fig. 3 –SUT n°3 back panel.
You can use simultaneously only one type or inputs (RCA or XLR) and only one type of
outputs (RCA or XLR) on your SUT n°3. You can mix rca or xlr in inputs or outputs: for
example you can use RCA inputs and XLR outputs, or XRL inputs and RCA outputs. It is
important to use good quality, shielded interconnects for all turntable connections; this will
help to minimize any noise or hum problems.
If your tonearm has a separate earth lead, connect it to the earth/grounding post located
on the rear of the SUT N°3. It may also be worthwhile connecting this earth/ground post to
the earth/ground post of your pre-amplifier/phonostage/amplifier (if one is available). This
will often further reduce low level noise or 'hum', however this is not always guaranteed,
so some experimentation is advised to ascertain the best arrangement.
This document and the information it contains are the property of IIA srl. It can not be reproduced or
modified by third parties without IIA's written approval.
www.audiodinamica.com
Page 5 of 11