Dangerous Music 2-Bus 매뉴얼 - 페이지 3
{카테고리_이름} Dangerous Music 2-Bus에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dangerous Music 2-Bus 7 페이지.
Dangerous Music 2-Bus에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지)
페이지 인쇄
Back Panel connectors and hook up
Back panel, left to right (viewed from rear).
Inputs 1-8
The 8 female XLR jacks are the main inputs.
Direct Out
Mixer can be fitted with a Direct Output board. These outputs are fed
post channel level control. This option should be specified if desired
upon ordering as it is a factory fit.
Main Outputs The first male XLR's are the main outputs to the mixdown A/D or tape
machine. Left is on top, Right on bottom.
Monitor Outs The Monitor Outs feed the mixed signal to the Dangerous Music
Monitor (or other monitor section).
EXP/LINK
This connector has a left and right buss inject for stacking capabilities.
The pinout is on page 6.
To Sends
Mixer can be fitted with the option to drive a Dangerous Sends unit.
This option should also be specified upon ordering as the Mixer and
Sends unit have to be fitted together for calibration and testing.
DC input
Newer units have a 5 pin DIN that connects to an International Power
supply. Please plug the DC connector into mixer before applying AC
mains power to avoid arcing the contacts.
Ground lugs The ground lugs are strapped for normal use. Should it be necessary to
isolate the chassis from the audio ground, the wire can be removed. The
top lug is chassis and the bottom is audio ground.
-3-