AudioEngine S8 설정 매뉴얼 - 페이지 6

{카테고리_이름} AudioEngine S8에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioEngine S8 13 페이지. Premium powered subwoofer
AudioEngine S8에 대해서도 마찬가지입니다: 사양 (2 페이지), 설정 매뉴얼 (10 페이지)

페이지 인쇄

speakers or another subwoofer. This Output is used whenever a

signal is connected to one of the two subwoofer inputs.

Note: The volume level of this Output connection is controlled

by the audio input source, not the volume control on the sub-

woofer.

4) Phase

The Phase control is used to blend the sound of the subwoofer

with the other speakers in your system. Phase is the degree to

which the subwoofer speaker and other speakers are moving in

and out at the same time. Once you have chosen a location for

your subwoofer, try turning the Phase control in small amounts

while you listen for the most bass from your favorite listening

position. Sometimes no difference will be heard, which is OK.

There is no correct Phase setting and it is not uncommon for the

subwoofer to sound similar at every setting, depending on your

room and location of the subwoofer. If you don't hear a differ-

ence go ahead and set the Phase knob to the 0 position.

5) Crossover

The Crossover control is used to set the subwoofer high fre-

quency cutoff point, which is the point at which the subwoofer

transitions to your other speakers. For example, if the Crossover

control is set to the 50Hz mark then the sub will play all frequen-

cies up to 50Hz. All frequencies from 50Hz and higher will then

be played by the other speakers. Fine-tune the Crossover setting

by ear for the smoothest blend with your main speakers.

The best setting of the Crossover control will depend on speaker

placement, room characteristics, and personal preference. As

with the Phase control, sometimes little or no difference will be

heard, which is OK.

Note: For surround sound setup refer to the manual for your re-

ceiver or processor for correct Crossover settings for your system.

S8 setup guide

The Crossover control is not active when using the LFE input

jack.

6) Volume

The Volume control is for matching the subwoofer speaker vol-

ume to the level of your speakers. Keep the volume low when

first setting up your system and then adjust to your preferred

level using different music and/or video sources. The best advice

we can give on matching the volume is to adjust for the stron-

gest bass without being "boomy".

Note: The subwoofer Volume controls the S8 subwoofer level

and does not

control the subwoofer output audio level or the input level vol-

ume. The overall system volume (subwoofer + speakers) should

be controlled directly from the audio source (TV, receiver, iPod,

etc.).

7) Power On/Standby indicator

This indicator LED will be GREEN when an input signal is present

(music playing) and RED when no signal is present (power-saving

standby mode). The S8 subwoofer will automatically enter

Standby mode after 15 minutes when no signal is detected.

Connections

Power

•

Verify that the power switch on the rear panel is in the OFF posi-

tion before making any connections.

•

Verify that the voltage selector switch is set to the correct oper-

ating voltage in your area.

•

Connect the AC power cord to the subwoofer and the other

end into a wall outlet. Do not use the outlet on the back of your

Audioengine powered speakers or receiver.