Freedom Lift Systems Trus-T-Lift 750 유지 관리 매뉴얼 - 페이지 4
{카테고리_이름} Freedom Lift Systems Trus-T-Lift 750에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Freedom Lift Systems Trus-T-Lift 750 10 페이지.
Freedom Lift Systems Trus-T-Lift 750에 대해서도 마찬가지입니다: 소유자 운영 매뉴얼 (10 페이지)
페이지 인쇄
TRUS<T>LIFT™ 750 LIMITED MAINTENACE MANUAL REVISION A, 16AUG2016
3.2.2 Inspect the drive screw
Inspect the drive screw for any irregularities, sharp edges or foreign
objects and dirt caught in the threads. Be sure no damage exists to the
drive screw and that it is entirely clean of debris. Replace screw if
damaged.
3.2.3 Clean and re-lubricate the drive screw
In order to lubricate the drive screw you must remove the main front panel
and a carriage guide frame panel. Use a clean rag to wipe all of the grease
off of the screw. Liberally apply Mobilith SHC-460PM grease on the drive
screw.
3.2.4 Inspect the drive belt
Remove the top cover and inspect the drive belt for wear. A small amount
of black rubber bits below the belt is normal. If there is any significant sign
of wear to the belt, replace.
3.2.5 Inspect for surface damage and complete touch ups to coatings
Wear and tear may occur on powder coated steel surfaces resulting in
scratches. Small points of damage can be wire brushed and touched up
with the small touch up paint containers that come with each lift RAM
ships out. This will extend the life and cosmetic look of you lift and is
particularly important in any environments that are coastal or potentially
corrosive.
3.2.6 Inspect cables
Tears in insulation should be patched where possible and if bare wire is
present new replacement cables should be purchased and installed by a
qualified technician. Consult your RAM dealer for spare parts should they
be required.
3.2.7 Inspect for correct functioning of toe plate – if applicable
The toe plate actuation mechanism may be critical to access and both the
mechanism and the toe plate itself should be examined. If there are any
concerns adjust the mechanism or repair/ replace it.
3.2.8 Re-check platform alignment and clearances
Buildings and construction "settles" over time and adjustments may be
required to ensure good clearances and alignment of the lift. Consult the
appropriate sections of the installation manual or RAM's technical support
team for guidance.
3 |
P a g e