Dangerous power FUSION 사용자 설명서 - 페이지 12
{카테고리_이름} Dangerous power FUSION에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dangerous power FUSION 15 페이지.
페이지 인쇄PROBLEM
Pressure gauge will not move
Fusion will not turn on
Fusion will not fire
Fusion will not fire with sensor
system on
Air leak from Barrel area
Fusion will not cycle
completely
Breaking paintball when
shooting out of the barrel
Chopping paintball internally
TROUBLESHOOTING
POSSIBLE CASUE
The pressure used was too hi
Not activated
Low battery power
Battery is connected
incorrectly to the PC board
Low battery power
Low pressure air
Solenoid may be out of place
LPR pressure is too low
No paintball present
Sensor system is unclean
Ball detent is damaged
Paintball broke inside
Valve pin is at incorrect
position
Valve pin is worn
Air pressure is too low
Low battery power
O-ring of striker is worn
Striker is worn
Barrel size does not match
paintball's
Ball detent is worn
Sensor system is not on
Low battery power
12
SOLUTION
Replace the gauge
Hold down operating button
for more than 4 seconds
Change battery
Check to see if the battery
cable were connected correctly
to the terminal
Change battery
Refill the air system
Open grip and press solenoid
forward
Adjust LPR pressure without
paintball present
Turn on the loader
See"Sensor System
Maintenance"
Call the authorized dealers for
replacement
See"Bolt and Sensor System
Maintenance"
Remove the LPR. Grease the
spring and valve pin
Replace them
Adjust the operating pressure
to 250 to 300 psi
Change battery
Replace the o-ring
Call the authorized dealers for
replacement
The stock barrel size is 0693,
change it if necessary
Call the authorized dealers for
replacement
Switch it to ON
Change battery