Daniamant L7A2 설치 및 유지보수 지침 매뉴얼 - 페이지 2

{카테고리_이름} Daniamant L7A2에 대한 설치 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniamant L7A2 8 페이지. Lifejacket light

Installation

The L7A2 lifejacket light is for use on solid foam, easy to don lifejackets only. The light housing may only

be fitted by the lifejacket manufacturer, as specialised tools are required; the L7A2 light assembly may

be changed by anybody.

To fit the light housing, refer to the diagram opposite.

Using a sharp implement, cut a hole 40 mm diameter by 50 mm deep in an upper corner of the lifejacket

in a position to ensure maximum visibility of the light when in use, ensuring that there is sufficient foam

wall thickness on the thinnest side to maintain its strength. Firmly press the housing assembly into the

hole, ensuring that the teeth grip the material around the hole to prevent it being pulled from under the

housing.

To fit the L7A2 light:

1. Clip the L7A2 light into the housing, orientating the lead position into one of the clearance grooves

in the housing.

2. Route the sensor lead to the bottom of the lifejacket to ensure that the sensor is under water when

in use, attaching the lead at several points to ensure that it will be secure in use.

The L7A2 light is switched on automatically when the sensor is immersed in water; no user action is

required. The light will remain on only while the sensor remains in contact with the water.

Routine service

L7A2 units are maintenance free, but the following checks should be made annually:

1. Inspect light for signs of damage or corrosion, if damage or corrosion visible, the unit is to be

replaced.

2. Test the light by immersing the sensor in water. The light must flash. Remove the sensor from

the water and dry it. The light must stop flashing.

Ensure that the sensor is in the "closed" position, as shown below.

Life / Replacement

The life of the L7A2 battery is five years from the date of manufacture; the expiry date is shown on

the label affixed to the L7A2. At the expiry date marked on the light, the removable light unit must be

replaced. Replacement lights are available from the manufacturer of the lifejacket.

1. Carefully detach the light unit by unclipping it from the permanent housing.

2. Free the sensor lead from its attachment points on the lifejacket.

3. Remove the light unit and dispose of it correctly

4. Fit the replacement light assembly as detailed under Installation.

Switching

IMO regulations require that a flashing light can be switched off. Accordingly, for approval purposes the

light may be extinguished by rotating the two halves of the sensor body, as shown below.

WARNING: the light will not operate when the sensor is "open"; operation requires that the sensor

is "closed" AND immersed in water. Other than for testing, the sensor must always be in the

"closed" position. Do not tamper with the sensor.

L7A2 ON

"Closed"

L7A2 OFF

"Open"