Conqueror FBC180 사용자 설명서 - 페이지 12

{카테고리_이름} Conqueror FBC180에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Conqueror FBC180 18 페이지.

GARAGE DOOR OPERATOR USER'S MANUAL

Deleting stored transmitters

1. Press and hold CODE , ' Su ' is indicated on the LED display.

2. Do not release the button until ' dL ' flashes.

3. ' ▬ ▬ ' is indicated on the LED display, this indicates that all stored transmitters have been

deleted completely.

1. Press and hold SET four seconds until 'P1' is indicated on the LED display. The operator is

now in programming mode.

2. Press SET again, 'OP' is indicated on the LED display.

3. Press and hold UP to set the open limit, 'OP' on the LED display will flash, release the

button until the door has reached desired position.

4. Press SET to confirm the open limit position, the LED will now indicated the 'CL'.

5. Press and hold DOWN to set the close limit, 'CL' on the LED display will flash, release the

button until the door has reached desired position.

6. Press SET to confirm the close limit position.

7. The door will now do a complete open & close cycle.

Press the transmitter

button twice.

Fig.14

Fig.15