Daniamant Echopilot FLS 3D 매뉴얼 - 페이지 8

{카테고리_이름} Daniamant Echopilot FLS 3D에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniamant Echopilot FLS 3D 17 페이지. Forward looking sonar

Industrivej 24C

DK-3550 Slangerup

Denmark

FLS 3D

Tel. +45 4737 3800

Fax: +45 4737 3809

www.daniamant.com

5. Installation Instructions

The choice of transducer position will have a major effect on final performance so please consider

carefully all factors and if in any doubt, telephone the factory.

The transducers should be mounted vertically, equidistant from the centreline. They must also be

the same distance from the bow. Take great care to mount the transducers with the brass arrows on

top pointing straight forward in the sailing direction.

Fairings, pads, tapered washers may be required during the fitting of the transducers. Consideration

must also be paid to access for maintenance.

Do not fit downstream of any other through hull fittings (for example intakes, log, toilet sea cocks etc)

and choose a location with good access for withdrawing the transducer for cleaning.

The transducer should ideally be vertical in the fore and aft plane at running trim. If it leans forward

the seabed will appear to slope up, and if it rakes aft then a degree of surface clutter may show.

Sonar cannot see around corners so before installing stand under the boat with your head near the

proposed position and check that you can see from your toes up to above the horizontal ahead. If

the boat has a full or deep forefoot and is shallow aft a forward mounted transducer maybe

necessary.

Each transducer is tuned to work with its own cable, as such the cable must not be cut, and the plug

must not be removed. If it does not reach, then move the location of the transducer interface or

NEVER CUT THE TRANSDUCER CABLE

FLS 3D Manual Version 1

Daniamant A/S