Audiolab 8300A 사용자 지침 - 페이지 6

{카테고리_이름} Audiolab 8300A에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiolab 8300A 13 페이지.
Audiolab 8300A에 대해서도 마찬가지입니다: 사용자 지침 (13 페이지)

5: Connections - 1

Signal Input

Balanced connections provide greater balanced headroom and

improved S/N ratio. If your source unit has a dynamic headroom

output uses the balanced connection. You need one XLR balanced

cable per channel. The socket connects to the player and the plug

normally connects to the amplifier.

If you cannot use the balanced input, connect a high quality stereo

screened RCA phone lead from the unbalanced input of the 8300A

to a suitable output of the source unit. 8300A has AUX1, AUX2,

VIDEO, TUNER, CD, PHONO six signal inputs which may be used

for connecting any line level source.

source.

Power AMP Input

For driving the power amplifier input directly from an external source.

Only operates when Pre-Power mode is selected.

PRE-AMP OUT 1&2

Low impedance pre-amplifier outputs for driving external power

amplifiers, sub-woofers or signal processors. Pre-Amp outputs are

switched off when integrated mode is selected or whenever amplifier

is muted.

Audiolab 8300A has one pair parallel trigger connections at the real panel, can be activated

by 8300CD's or any other source's trigger output. 8300A can also provide a trigger signal

to another 8300A's or any other amplifier's trigger input. If you have an 8300 system, we

advise connecting the triggers. This will enable all 8300 units to be brought in and out of

standby along with the trigger connections.

To connect to your control unit, you will need a cable with one end to match the trigger

output of the control unit and other terminating in a 3.5mm jack plug. For Audiolab 8300

series, this will be a 3.5mm to 3.5mm interconnect.

Before connecting the 8300A to the mains supply make sure that all the other

connections to your system have been properly and securely made. Make sure the

ON/OFF switch on the 8300A is switched off. Switch the mains supply off at the

wall socket, and then, using the cable supplied, connect the socket on the back

of your 8300A to an AC supply outlet. The 8300A is now ready for operation.

Page 5