Daniel Hertz M2 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Daniel Hertz M2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniel Hertz M2 12 페이지. Speaker/18” subwoofer

Connections to the amplifiers

One Daniel Hertz M5 TELIKOS mono power amplifier

is required for each M2 speaker. One channel of M5 power

amplifier is required for the M3. Daniel Hertz Premium 500

speaker cable shoud be used for these connections.

Stereo Configuration: Connect the Main Outputs of the

M6 preamplifier to the Inputs of the M5 amplifiers with

Daniel Hertz Silver 1 cable. Set the M5 front panel filter

switch to FLAT. Set the front panel M5 attenuators to 0dB.

2.1 Configuration: As above, but with the following

changes: a) in addition, connect the MONO subwoofer out-

put of the M6 Preamplifier to the input of the M5 driving

the M3. b) Set the filter switch of the M5's driving the M2's

to HPF (High Pass Filter) . c) Set the filter switch of the M5

driving the M3 to LPF (Low Pas Filter). d) The front panel

attenuator of the M5's driving M2's should be set to -2dB,

and e) the front panel attenuator of the M5 driving the M3

should be set to -0dB. (The 2dB compensates for the dif-

ference in efficiency due to the large mass of the 18" sub-

woofer cone.)