Daniela DAN6SO 사용자 설명서 - 페이지 7
{카테고리_이름} Daniela DAN6SO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniela DAN6SO 12 페이지. 60cm ducted slideout rangehood
페이지 인쇄INSTALLATION
•
Before beginning installation, to better handle the hood, we advise removing the
aluminium filter.
•
Before fixing, the outlet exhaust duct for air evacuation to the outside must be installed.
Use an outlet exhaust duct with:
•
Minimum indispensable length
•
Minimum possible bends, please note
that for every bend in your ducting
you will lose 100m3 of extraction
•
Maximum angle of bend is 90 deg.
•
Certified material (according to local
building and fire regulations), and as
smooth as possible on the inside.
•
It is advisable to avoid any drastic
changes in duct cross-section
(recommended diameter 125mm).
•
Decide on the position of the hole
for the air outlet. The hole must be
in the ceiling, according to your
requirements, but must be in vertical
line with your hood. Bear in mind that
the hood can expel air through the
top air outlet only.
INSTALLATION OF ELECTRICAL
•
The electrical wiring must be done by a qualified technician in accordance
with all applicable codes and standards.
•
Turn off electrical power at the service entrance before wiring.
•
If the supply cord is damaged, it must be replaced by the manufacturer
or a Daniela Appliances Pty Ltd service agent, to avoid a hazard.
•
Do not use the plug and an extension cord other than the ones initially
supplied with the hood.
P
I
02 9604 1226
E
I
INSTALLATION & USE
W
|
danielaappliances.com.au
PA G E 7