3Ware 3WARE 9650SE 사양 - 페이지 2

{카테고리_이름} 3Ware 3WARE 9650SE에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Ware 3WARE 9650SE 7 페이지. Remote battery board
3Ware 3WARE 9650SE에 대해서도 마찬가지입니다: 사용자 설명서 부록 (1 페이지), 사용자 설명서 (11 페이지), 설치 매뉴얼 (4 페이지)

페이지 인쇄

Using the AMCC 3ware® I2C Multiplexer with a Supermicro® Backplane

Mounting the I

C MUX

You can mount the I

C MUX in an empty slot or any available space in

the chassis.

The I

C MUX has two break-away sections that can be removed to

make the I

C MUX card smaller. They can also be used as mounting

points for one or two Battery Backup Unit (BBU) batteries, to

maximize space usage inside the enclosure.

You may wish to install the backplane and controller in their respective

enclosures before connecting them via cables.

Scored line

Connecting to Power

Power is supplied to the I

C MUX via a standard 4-pin Molex power

connector.

Cable Connections

In order for LEDs to be associated with the correct drives, the cable

connections between the I

Supermicro backplane need to map to their corresponding port number

or port number groups.

Example:

controller must connect to the port 1 SATA connector on the

Supermicro backplane. In addition, the I

connector cable must use one of its two cable ends to connect to

Sideband connector #1 on the backplane, which manages I

for backplane SATA ports 0-3.

Scored line

The illustrations on pages 3 through 5 show the cable connection

patterns between the I

Supermicro backplanes.

The 826TQ and 836TQ backplanes illustrations show a 9650SE-16ML

RAID controller and the 846TQ illustration shows a 9650SE-24M8

RAID controller.

Cable Pin Definitions

Tables showing the proper cable pin definitions are in the Appendix on

page 7.

Jumper Settings

By default, Supermicro SAS Backplanes are set to use I

enclosure services. Therefore, the default jumper settings on the

backplanes should not normally need to be adjusted. However, if

the default settings have been changed for any reason, you will

need to change them to the I

It is a good idea to review the jumper settings and make sure they are

correct. Tables showing the proper jumper settings for each backplane

are provided in the Appendix on page 6.

C MUX, 3ware RAID controller, and

The drive cable that connects to port 1 on the 9650SE RAID

C MUX port 0-7 (J4)

C MUX and each of the three different

C jumper settings.

AMCC 3ware I

C services

C to manage

C MUX Documentation