AUDIOLINE Baby Care 1 사용 설명서 - 페이지 15

{카테고리_이름} AUDIOLINE Baby Care 1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AUDIOLINE Baby Care 1 20 페이지.

페이지 인쇄
3

Setting up

The parent and baby units can be operated with the power supplies provided or with batteries (not
included). Of course, you can also use the baby unit with batteries and the parent unit with a power
supply or vice versa.
Note: We recommend the use of batteries in order to reduce the production of electromagnetic fields.
3.1

Operation with plug-in mains power supply

Use the power supply with the cable tidy for the baby unit. With this, you can change the length of the
cable from the socket to the baby unit so that it is always just right. To change the length, press hard on
the middle of the cable tidy. Then uncoil or rewind the required length and close the cable tidy.
Note: If the cable tidy has not yet been connected to one of the power supplies, then either of the two
power supplies can be used.
Insert the small round plug into the socket provided on the rear of the parent or baby unit and plug the
power supply into a mains socket (230V/50Hz).
Ensure that the plug-in mains power supply is adequately ventilated.
3.2

Battery operation

3.2.1

Fitting batteries in the baby unit

Note: You can also use rechargeable batteries for the parent and baby units. However, these will not be
automatically recharged via the power supply provided.
1.
The battery compartment is located on the rear.
2.
Open the battery compartment with a small screwdriver.
Note: For safety reasons, the battery compartment is locked by means of a screw so that the baby
cannot open the compartment. This ensures that the baby is unable to come into contact with the
batteries.
3.
Insert four Type LR14 (Baby) batteries. In doing so, ensure that the polarity is correct.
4.
Close the battery compartment.
The batteries should be changed immediately if the indicator light (4) shows red during battery operation.
3.2.2

Fitting batteries in the parent unit

1.
The battery compartment is located on the rear.
2.
Rotate the belt clip upwards.
3.
Open the battery compartment with a sharp object.
4.
Insert four Type AAA (Micro) batteries. In doing so, ensure that the polarity is correct.
5.
Close the battery compartment.
The batteries should be changed immediately if the indicator light (10) shows red during battery
operation.
- Setting up -
15