BrakeBuddy Vantage 설치 매뉴얼 - 페이지 4

{카테고리_이름} BrakeBuddy Vantage에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BrakeBuddy Vantage 6 페이지.

antage

The BrakeBuddy Wireless Remote provides 2-Way

communication from the RV to the towed vehicle and provides

visual indication on problems that are occurring (Fig. 13).

F - Main Unit Error (red light will activate) Stop and check the

main unit diagnostics for error.

G - Breakaway Warning (red light and audible signal will

activate) Stop Immediately!

H - Battery Low on Remote (replace with new AA battery)

1. To remove the BrakeBuddy from your towed vehicle, unplug the 12-volt adapter from the towed vehicle (the air

pressure in the system will automatically drain).

2. Unplug the breakaway junction box harness from the top of the BrakeBuddy and coil the wire under the

dashboard or floor mat.

3. Adjust the seat back and remove the clevis after the air pressure has drained.

4. Disconnect (unclip) the breakaway safety coil from the breakaway junction box.

Information to User:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio / TV technician for help.

CAUTION: Changes or modifications not expressly approved by Hopkins Manufacturing Corporation could void

the user's authority to operate the equipment.

311-0288-053 Rev. A 11/05

OPERATION INSTRUCTIONS

REMOVAL INSTRUCTIONS

antage

FIG. 13

Phone (800) 470-2287

www.brakebuddy.com

1 2 3 4 5 6 7

Printed in U.S.A