AUDIOLINE TAM-809 사용자 설명서 - 페이지 5

{카테고리_이름} AUDIOLINE TAM-809에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AUDIOLINE TAM-809 11 페이지.

SETUP

OUTGOING MESSAGE (OGM)

# Ensure the machine is switched on (initial connection red light flashes, green light

on).

# Press and hold the

# After a beep tone record your message (maximum: 30 seconds).

# When finished, release

# Repeat procedure if you wish to change OGM message.

# # Press and hold the

# # Press and release the

# # Repeat the two points above to set Hours, Minutes an AM/PM settings.

# Press and release the

announce the time set.

# If you make a mistake, repeat the above procedure.

# To check the settings, press and release the

time' is announced, the time has not been set.

NOTE: If there is a delay of 10 seconds between button presses the procedure will

time out. If you do not set the time, the system will not announce the time each

message was received.

The switch 2/6/TS at the rear of the system determines how the system answers calls.

2 = the system will answer a call after 2 rings

6 = the system will answer a call after 6 rings

T/S = the system will answer a call after 2 rings if new messages are recorded and

after 6 rings if no new message exists.

button.

[OGM]

button, your greeting will now replay.

[OGM]

button until a day is announced.

[TIME SET]

button repeatedly to set the day.

[TIME SET]

button to confirm setting.

[TIME CHECK]

button to store settings. The unit will

[TIME CHECK]

AUDIOLINE TAM809

button. If 'Please set

[TIME CHECK]