AudioMate HCA-100 매뉴얼 - 페이지 4

{카테고리_이름} AudioMate HCA-100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioMate HCA-100 18 페이지. Wireless digital audio player

Note: You have to update your Windows XP to SP2 before you enable

WCN function and install Windows Media Connect media server.

Wired Ethernet Connection (option)

Depending on your router requirement, you can select either dynamic IP

address assigned by your DHCP server (or router) or you can assign static IP

address for AudioMate manually. You are always recommended to use

dynamic IP address ("Audo" mode) for wired connections, if applicable.

Using dynamic IP address assigned by DHCP server ("Auto" mode) –

Factory Default

To establish wired Ethernet connection, you just need to simply connect RJ-45

cable (with dynamic IP address assignment) to AudioMate, AudioMate will get

IP address from DHCP server and activate Ethernet connection automatically.

For the details of DHCP server setup, please refer to your DHCP-ready

broadband router user's manual.

Go to Main Screen

directly)

select "Interface Setting"

select "Network Mode"

Using static IP address

You can use static IP address for the wired connections. To use static IP

address for network connections, you have to assign and specify the dedicated

IP address, corresponding network Mask, Sub-net, DNS address, etc...

information at both router side and AudioMate.

Go to Main Screen

directly)

select "Interface Setting"

select "Network Mode"

dedicated IP address for AudioMate

mask

go to "Default Gateway" and give gateway IP address (usually the IP

address of your router)

address

Settings (or press "Setup" hot key on remote controller

select "Ethernet"

select "Auto"

Settings (or press "Setup" hot key on remote controller

select "Ethernet"

select "Static

go to "DNS Server" setting and enter DNS server

go to "IP Address" and assign

Go to "Subnet mask" and enter the

go to "IP Setting"