Danley DBH218 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Danley DBH218에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danley DBH218 8 페이지.
Danley DBH218에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

Section

Your New Subwoofer

1.1

Unpacking

For most of the Danley Sound Labs line we recommend that it be unpacked by two or more people. Refer to the spec sheet for

product weight. Remove tape and open top flaps. Lay the box on its side and slide the subwoofer out. Remove the packaging

wrap.

1.2

Inspection

Check to make sure the product is not missing hardware of any kind. If any brackets or additional accessory hardware is missing,

please don't hesitate to contact Danley Sound Labs.

1.3

Shipping Damage

If your subwoofer appears to have been damaged in shipping, please take clear photographs and contact Danley Sound Labs

immediately.

Section 2

2.1

THE TAPPED HORN

The Danley Tapped Horn Subwoofer™ is a proprietary design which allows us to build physically small subs which are very

efficient especially at the low end of their range and are virtually linear in their passband. Subjectively the TH series produce

very deep bass from generally very small boxes. They are unlike conventional horns in that combining multiple TH boxes together

results in more output, but not significantly more extension.

2.2

THE DANLEY BASS HORN

The DBH subwoofer is a Danley take on a conventional design. The DBH subs feature a front loaded, folded horn design. The

DBH subs behave conventionally in that adding boxes together not only increases the output, but extends the low frequency

response downward.

Section 3

3.1

What Size Amplifier to Use

Selecting the right amplifier for your subwoofer depends on a variety of factors and uses. The owner is ultimately responsible for

choosing the best amplifier or amplifiers for the application. We recommend choosing an amp that is rated no less than continuous

and no higher than program. Please note "Continuous" does not mean "forever"! Most subwoofer manufactures, including Danley

Sound Labs, subscribe to the AES standards for subwoofer power ratings.

3.2

Connecting to the Tapped Horn

Your Danley subwoofer has two NL4 ("speak-on") connectors located on a panel on the rear of the box. With the exception of

the TH812, TH221, TH412, all TH series subwoofers are wired as passive. The NL4 connectors are wired parallel.

Pinout: Passive

Positive

amp 1

1 -

Negative amp 1

Pass Through

2 -

Pass Through

Page | 4

DANLEY OWNER'S MANUAL

Understanding the Difference

Initial Set Up