Caslon Maxit 927 운영 및 유지보수 매뉴얼 - 페이지 8

{카테고리_이름} Caslon Maxit 927에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caslon Maxit 927 13 페이지.
Caslon Maxit 927에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (12 페이지)

페이지 인쇄

Adding Adhesive

Maxit adhesive comes in pellets which normally stick together in the bag. Either cut the

required amount with a knife or alternatively, refrigerate the product for approximately 2

hours. It is then easy to tear off the adhesive in the pieces you require.

When the adhesive level drops to the 'add level' add more adhesive. It is important to

maintain the adhesive level at, or above, the 'full' level. If not, you will not achieve the

correct coating and it will take longer to warm up in the morning.

Pull down the front cover. Place approximately half of the adhesive pellets in the front of the

tray. You do not need to wait for the pellets to melt before using the Maxit. The bag is made

from a special material and is dissolvable in the hot adhesive.

Cleaning

WD-40, although a lubricant, is excellent for cleaning adhesive from the outside casing. If

adhesive appears on the top roller, remove the screws from the sides of the Maxit, slide off

the top halves of the covers and swivel back the top roller. Then use WD-40 to clean it.

Page 7