Belco Multi-Biometric 빠른 시작 매뉴얼 - 페이지 18

{카테고리_이름} Belco Multi-Biometric에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Belco Multi-Biometric 18 페이지.

Notice the following setting interfaces are available.

IP address:

Default IP is 192.168.1.201. You can modify it. But do NOT use an IP address already being used

by another network device.

Subnet Mask:

Default mask is 255.255.255.0. You can modify it.

Gateway:

Default gateway address is 0.0.0.0. You can modify it.

RS232: If using RS232 communication, select "On".

RS485: If using RS485 communication, select "On".

Tips: RS232/485 only 2 to 1

Baud rate: This parameter is used to set the baud rate for the communication between the device

and the PC. It includes five options: 9600, 19200, 38400, 57600, and 115200.

Device ID: This parameter is used to set the ID of device from 1 to 254. If the RS232/RS485

communication is adopted, you need to enter the device ID on the software communication

interface.

Comm. Key: you can set a password for the connection between the device and PC. The default

password is 0, and 1 to 6 digits passwords are supported.