Audiopax 5 매뉴얼 - 페이지 4

{카테고리_이름} Audiopax 5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiopax 5 10 페이지.

Installation

Your Model 5 is shipped in a single box containing:

● The preamp unit

● The external power supply

● Two dc cables

● A remote control

● A small antenna for remote control reception

● Reserve fuses

Your manual is available for download on our website: www.audiopax.com.

Model 5 should be installed in a location with natural ventilation and at least 10

cm (4 inches) of free space above its handles (use in enclosed cabinets could

endanger its components and void your warranty). Both the preamplifier and its power

supply must be installed away from equipment that may generate electromagnetic

interference (such as power conditioners) and the power unit must be at least 50 cm

away from the main chassis.

Recommendations for its installation and use:

● Install it with all system equipment turned off. Also, make sure that the

power on/off and standby switches of the power supply and preamplifier

are turned off.

● Connect the source and the preamplifier with the two supplied dc cables.

The colors of the cable connectors match the colors of the cabinet

connectors and there is no possibility of reversing these cables, which

are only pluggable in the correct position.

● At the power supply module: Install the supplied antenna into the

corresponding input and set the grounded/ungrounded switch to the

grounded position.

● On the preamplifier module: Select both rear switches to the upper

position ("unbalanced" and "High Gain").

● Make all necessary audio input and output connections.

● Connect the AC power cord using the proper voltage - Model 5 can be

supplied for 120V or 230V, but you cannot change this selection on your

own (contact Audiopax if necessary).

● We recommend that the power supply be continuously turned on and all

on/off operation be performed by the preamplifier front panel "standby