Danner PONDMASTER HAMPTON CPF2000U 관리 및 작동 지침 - 페이지 6
{카테고리_이름} Danner PONDMASTER HAMPTON CPF2000U에 대한 관리 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danner PONDMASTER HAMPTON CPF2000U 11 페이지. Pressurized filter system
5
SET UP FILTER MEDIA
Unpack the Main filter unit. Open the cover by pulling latches out at bottom then
pivoting them outward at the top. Then pull straight up on cover.
If your filter includes the UV Clarifier, carefully lift the cover and check that UV bulb
is connected to the fixture inside the quartz sleeve. If it has become dislodged
during shipping see separate sheet included with UV units
for instructions to access bulb. Carefully place the cover
aside.
Debris Filter Media Pad fits into the top tray.
BioMatrix filter ball media is used in the bottom tray or trays
depending on your model. If your BioMatrix filter ball media
is packed in plastic bags, empty them evenly into the
bottom tray(s) and dispose of the bags.
When finished, replace cover
paying careful attention to
align intake / outlet ports with
molded handle in filter drum.
Close latches - - Clip tops first
then press bottoms inward.
INTAKE
and
OUTLET
MOLDED
HANDLE
6
HOSE ASSEMBLY
Connect hoses from pump
and to water return as
shown using stainless steel
hose clamps (not supplied).
We recommend using an
in-line check valve before
the pump connection.
7
TEST FILTER SET-UP
Once hoses are connected, the filter should be checked with the pump
running. Check that hoses are supported well enough to avoid
stressing the plastic intake and outlet ports once they are weighted
with water during operation. Supporting the hoses will help prevent
kinked tubing. Check for leaks and tighten hose clamps if needed.
6
IN
OUT
FROM
TO
PUMP
POND