Audiophile APS PurePower 500 사용자 설명서 - 페이지 13

{카테고리_이름} Audiophile APS PurePower 500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiophile APS PurePower 500 19 페이지. 120 volt models audio power supply

Operation

Turning the PurePower On

After the APS is connected to a power outlet, it conducts a self-test and enters Standby mode. To

turn on the APSoutput power, press the On | button on the front panel. The ~ indicator illumi-

nates and the bar graph indicators display the percentage of available power being supplied by

the APS.

Starting the PurePower APS on battery

To turn on the APS without using utility power, press and hold the On | button for a least four

seconds. The APS supplies power to your equipment and goes into Battery mode. When the APS

starts on battery, it does not conduct a self-test to conserve battery power.

Turning the PurePower APS off

To turn off the APS:

· Press and hold the off button for approximately three seconds.

· The APS switches to Standby mode and removes power from the APS output receptacles.

· Unplug the APS from the power outlet; the APS shuts down in five seconds. All front panel

indicators flash briefly prior to shutdown.

· If you do not unplug the APS, it remains in Standby mode.

NOTE: Pressing the off button while the APS is in Battery mode causes the APS to shut down

immediately.

Initiating the Self-Test

Press and hold the alert button for three seconds to initiate the self-test. During the five-second

test, the bar graph indicators cycle through twice. If the APS finds a problem, a LED indicates

where the problem is. For more information, see the "Troubleshooting" section.

NOTE: The batteries must be fully charged and the APS must be in normal or standby mode to

perform the self-test.

12 |

Pure Power in > Pure Sound out