Audiophonics HPA-S600NCX 사용자 설명서 - 페이지 8

{카테고리_이름} Audiophonics HPA-S600NCX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiophonics HPA-S600NCX 10 페이지.

Operation of the device

Power the device

First, connect the power supply connector (2) of the amplifier to a main power outlet using the supplied power cable. Press the ON/OFF button (1) on the unit. The

LED on the button will light up. The amplifier is now turned on.

Note: Before plugging in and supplying power to the unit from a main power outlet, be sure to check that the power supply voltage selector on the bottom of the ampli-

fier is set to match the voltage supplied by your household electrical system. Incorrect power supply voltage settings can result in equipment and physical damages.

Input selection

Each channel allows you to select an input independently thanks to two switches (one per channel). Move the switches up to select the XLR input. Move the switches

down to select the RCA input.

Trigger usage

This amplifier has a built-in trigger input (3) and trigger output (7) operating in the 5-12VDC range. These can be connected to the trigger inputs and outputs of other

devices to set up a chain that automatically turns on your audio system when a signal is received and turns it off when no signal is detected.

Settings

The Audiophonics HPA-S600NCX amplifier has a 4 level gain control and allows to activate or not its buffer as well as its front panel LED. These settings can be made

with jumpers and DIP switches positioned under the device.

Gain setting

The HPA-S600NCX provides a gain level adjustment. Four different gain levels are available. The settings are made by means of a DIP switch. The following diagram

details the different possible configurations:

Buffer setting

The amplifier includes a buffer, which is activated by default. However, if necessary, it can be deactivated by placing the jumper in the Bypass position. The possible

configurations are as follows:

Power LED ON/OFF setting

The ON/OFF button of the amplifier is surrounded by a status LED, which is lit by default when the device is turned on. This can be disabled by means of a jumper

on the bottom of the unit. The configurations are as follows: