Addonics Technologies DCHDIES 사용자 설명서 - 페이지 3

{카테고리_이름} Addonics Technologies DCHDIES에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies DCHDIES 4 페이지. Diamond combo hard drive

For IDE Drive

Note: Set up your IDE hard drive

as Master device

Connect the 4-Pin Molex cable to

the power connector on the IDE

hard drive. Carefully place the IDE

hard drive with the label facing up

into the Diamond enclosure. Push

the hard drive towards the back end

to secure the drive connectors onto

the Diamond enclosure's IDE

connector.

Step 4

Turn the Diamond enclosure over

with the hard drive mounting holes

facing up. Use the included flat

head screws to secure the hard

drive onto the bottom of the

enclosure and turn in the screw to

the "LOCK" position.

Cable Connections

Power: Connect the 6-pin Mini DIN power cable (provided) to the 6-pin

Mini DIN power connector located at the back of the enclosure.

Data:

Model: DCHDSAES & DCHDIES

Connect the eSATA to eSATA cable to the eSATA connector located at

the back of the enclosure and the other end of the eSATA cable to the

eSATA connector on your SATA host controller with eSATA ports.

Model: DCHDSAEU & DCHDIEU

Connect the eSATA to eSATA cable to the eSATA connector located at

the back of the enclosure and the other end of the eSATA cable to the

eSATA connector on the USB2.0 to eSATA adapter. You can now plug

the adapter to a USB port on your system.

Powering On Enclosure: To power on the enclosure, move the switch

located at the back of the enclosure to the ON mode. When the switch is

turned on, the LED light beside it would light up to indicate power and

also drive access.

Note: There are no drivers needed to use the eSATA cable as long

as the drivers are installed for the Serial ATA Controller card/chip. It

is plug and play.

Mini-Din power

connector

eSATA

On / OFF

connector

switch