CASO DESIGN 3161 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} CASO DESIGN 3161에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CASO DESIGN 3161 4 페이지. Mincer attachment for km 1800 black

페이지 인쇄

Assembling the mincer

Undo the front

cover screw and

remove the cover

of the accessory

drive shaft.

Insert the auger

(4) into the auger housing (3).

Place the blade (5) in front

of the auger so that the flat

sides face the perforated

disc. The blade is sharp, so

be careful with it.

Place the desired perforated disc (6)

in front of the blade paying atten-

tion to the two recesses (left/right)

of the auger housing.

Using the mincer:

Cut the desired ingredients into pieces that

fit into the feed chute.

Check that the mincer is firmly mounted on

the motor head.

Put the ingredients into the feed chute and

the filling tray.

Place a container under the outlet.

Plug the power plug into the outlet.

Tap the

We recommend speed level 3–5.

Start the appliance by pressing the

button.

Carefully press the ingredients down with

the tamper (1).

After use, switch off the appliance with the

button and pull the plug out of the

outlet.

button and select a speed level.

Put on the

fastening ring

/ cover nut (7)

and tighten it

clockwise.

Place the min-

cer attachment

on the drive

shaft and tighten

the screw.

Place the feed tray

(2) on the auger

housing.