audiophony CP2 사용자 설명서 - 페이지 7
{카테고리_이름} audiophony CP2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. audiophony CP2 12 페이지. Stereo compressor/limiter/gate
페이지 인쇄ENGLISH
[8] - Attack
This knob determines the response time of the
compressor once the threshold has been reached. Can
be configured from Slow to Fast.
[9] - Ratio
This function can be used to adjust the compression
rate applied to the incoming signal. From 1:1 (no
compression) to :1 (close to a Peak limiter with a high
attack value).
[10] - Soft Comp
This button allows you to switch from Hard Knee to
Soft Comp mode. The LED of this button will light up in
yellow when the Soft Comp function is activated, and
remains off while the Hard Knee mode is activated.
In Hard Knee mode, the compression threshold,
precisely determined by the Threshold button, is the
point from which the compressor will be activated in
accordance with the determined ratio.
[11] - Threshold
It is the threshold from which the compressor will be
activated. Can be configured from -40 dBu to +20 dBu.
In Soft Comp mode, this value represents the center of
the zone around which the compression is lighter.
[12] - Gain Reduction viewmeter
Displays the gain reduction level applied by the
compressor and/or gate.
[13] - Threshold (Gate) indicator
These 3 LEDs indicate the current relation between
the incoming signal and the threshold value previously
determined. The green LED indicates that the
incoming signal is below the threshold value, while
the red LED lights up when the signal has reached the
aforementioned value.
The orange LED is only available in Soft Compo mode
and indicates that the signal lies in the Soft Comp area
as defined by the threshold.
[14] - Contour
When this function is activated (and its LED lit), the
compression circuit does not take into account the low
frequencies, thus avoiding the "pumping" effect which
may occur when a signal is over-compressed.
Page 8
CP2 - Stereo Compressor/Limiter/Gate
[15] - Release
Allows you to determine the amount of time required for
the Gate to close and prevent the signal to go through
the audio circuit once the threshold has been reached.
[16] - SC Enable
Allows you to activate the connections required for an
external processing of the detector signal. It has no
effect if there is nothing plugged into the sidechain loop,
however the indicator will still light if the side chain is
activated.
[17] - Threshold
Threshold from which the Gate will act on the incoming
signal. Can be configured from OFF to +15dBu.
[18] - Threshold (Gate) indicator
These two LEDs indicate the relation between the
incoming signal and the threshold value previously
determined. The red LED will light up when the
incoming signal is below the aforementioned value while
the green LED will light up when the signal is above the
threshold (thus going through the gate).