Dansing Wings SCG37 사용 설명서 - 페이지 6
{카테고리_이름} Dansing Wings SCG37에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dansing Wings SCG37 8 페이지.
페이지 인쇄05
安装拉线
Install the stay wire
05-1
机翼拉线安装示范
Display the stay wire for wing
C2
C4
Steel wire
C5( lock)
C1( lock)
B1(lock)
A1(lock)
A1→A2
B1→B2
C1→C2→C3→C4→C5
9
M2.5
在钻孔内点入少量CA胶，待固化后再拧入
螺丝。
自攻螺丝
Put a small amount of CA glue into
Self-tapping screw
the drill hole, and screw it in after
solidification.
M2x11mm
确认舱身内的2块预留小木块位置，并在机身侧面钻孔，2个孔钻在小木
块位置。
Confirm the position of two reserved wooden blocks in the cabin
and drill holes on the side of the fuselage. Two holes are drilled
on the wooden blocks.
PT17共设置3条拉线，图中按颜
色区分拉线，按数字顺序进行安
装。
A2( lock)
There are totally two stay wires
for this PT-17,pls identify them
B2( lock)
by color and proceed the
wiring by numerical order.
安装时请注意细节图。
Please pay attention to the
details during installation.
C3
细节1
Detail 1
铝扣
Alu. buckle
卡扣
Buckle
尾翼拉线安装示范 Display the stay wire for tail wing
05-4
上图垂直尾翼的记号位置钻2个孔，在孔内点入少量CA胶。
Drill two holes at the mark positions of the vertical tail as shown
above and put a small amount of CA glue into the drill hole.
05-6
M1.5
细节2
Detail 2
卡扣
Buckle
铝扣
Alu. buckle
铝扣
Alu. buckle
卡扣
Buckle
05-5
M1.5
上图水平尾翼的记号位置钻2个孔，在孔内点入少量CA胶。
Drill two holes at the mark positions of the horizontal tail as shown
above and put a small amount of CA glue into the drill hole.
如图在机身尾部钻孔，在孔内点入少量CA胶。
Drill holes at the tail of the fuselage as shown in the figure, and put
a small amount of CA glue into the holes.
铝扣
Alu. buckle
M1.5
10