Audiophony PA GO Series 사용자 설명서 - 페이지 6

{카테고리_이름} Audiophony PA GO Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiophony PA GO Series 16 페이지.
Audiophony PA GO Series에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄
Audiophony PA GO Series 사용자 설명서
English

3 - Installation

3.1 - Connecting the receiver
AUDIO OUTPUT
UNBALANCED
BALANCED
AUDIO OUTPUT
UNBALANCED
LINE MIC
BALANCED
BALANCED OR
UNBALANCED CABLE
MIXING DESK
AMPLIFIER
AUDIO OUTPUT
UNBALANCED
BALANCED
Page 6
GO series microphones - Lavalier, headband or handheld UHF systems
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
1
9
13
DC INPUT
12V 500mA
CHANNEL
SQ
5
9
1
13
AC ADAPTER
LINE
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
9
1
13
- Connect the supplied AC adapter to
an electrical outlet, and to the DC
12V socket located at the rear of the
GOMono receiver.
- Connect the audio output to your
mixing desk with either a balanced
XLR cable or unbalanced Jack 6.35.
- Do not use both the unbalanced and
balanced outputs simultaneously
as it might cause signal losses and
increases parasitic noises.
- In order to preserve a good sound
quality and prevent distortions, you
can adjust the volume by following the
instructions below:
- If you are using a microphone input of
your mixing desk or amplifier, turn the
volume to half power (approximately),
the balanced and unbalanced outputs
level will then be close to 77 mV.
- If you are using a line level input of
your mixing desk or amplifier, turn the
volume to 3/4 of the maximum power,
the unbalanced and balanced outputs
SPEAKER
will then be close to 770 mV.
MIC
- Adjust the output level to the input
level used by the mixing desk.
- MIC level: - 20dBm
- LINE level: 0 dB