Audiopipe APCL-3000ID 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Audiopipe APCL-3000ID에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiopipe APCL-3000ID 12 페이지. Class d power amplifiers 1800/3000 w

We recommend to have the installation done by an Authorized Audiopipe Dealer.

Required power, ground wire and proper external fuse as below:

Model

APCL-18001D

APCL-30001D

We recommend a fuse should be installed away 0.2m from the battery. The ground wire

should be connected directly with the chassis of your vehicle which should be metal to

metal ground point connection. The amplifier must be mounted securely at a solid, dry

and low vibration surface in the trunk or passenger area. Fix the amplifier in an open air

area to insure proper heat dissipation. Fix the amplifier in a place where can access easily

to set the input controllers. Install all amplifier cables as far as possible from car electrical

cables such as the car ignition cable.

IMPORTANT:

• When bridging two amplifiers please refer the bridging wiring chart.

• When bridging two amplifiers you should use same model amplifiers.

• Please make sure the negative speaker terminal of two amplifiers are connected by

the same gauge cables as the positive terminal being used.

• DO NOT connect any signal cables with the input RCA jacks when bridged as slave unit.

• The LPF, Input level and remote functions will be disabled on slave amplifier when

bridged.

• All the functions of the slave amplifier will be adjusted by the master amplifier.

Fuse

120 AMP

200 AMP

Wire

0 to 2 Gauge